AULTEN 20 KVA (190V-270V) Single Phase Air Cooled Servo Voltage Correctors

Full protection design for Over Voltage, Under Voltage, Short Circuit to protect your equipment
Multifunctional Digital Display showing Output Voltage (OP), Input Voltage (IP), High Voltage (Hi), Low Voltage (Lo), 5 Second Initial Time Delay Countdown, you can monitor the voltage performance in real-time mainline stabilizer home.
Complete Protection for all your appliances with inbuilt High Voltage Cut, Low Voltage Cut, Short Circuit enhancing their performance and life cycle, automatically cuts the power supply during huge surges and fluctuations.

Product details
Manufacturer: Aulten

Country of Origin: India
SPN-UGL

The Servo Stabilizers are ideal choice for used as Mains Voltage Stabilizer, they provide continuous and precise voltage regulation without any break in supply. AULTEN Stabilizers are highly power efficient having less than 2% no load losses.

If your unit is suffering from low/high/unbalanced voltage, you need to install a stabilizer soon. Industrial units having acute/ higher failure rate of electrical equipments such as bulb, tubes, chokes, starter, contractor coils, motors etc., should verify that it may be due to voltage variation (esp. High voltage). You may note down hourly readings of incoming voltage for a few days continuously. If you find that input voltage is lower or higher then 230V (single phase)/ 400V (three phase) even for few hours day, then you definitely require a stabilizer.

Servo Voltage Corrector Technical Specifications

Specification	20KVA (Single Phase)
Phase	Single Phase
Voltage Input	190-270V
Frequency Input	50Hz
Voltage Output	230 V ± 1%
Delay Output	0 - 10 sec
Over Volt Output	AC 250V ± 5V
Low Volt Output	AC 180V ± 5V
By pass Protection	Provided (Optional)
Over Load Trip Protection	Provided
Cooling System	Air (Cooled)
Full Load Efficiency	Better Than 95%
No Load Efficiency	Less Than 2% of Rated Load
Temperature	5ºC - 40ºC
Humidity	Upto 95%
Floor Mounting	Floor Mounting
Class Insulation	B Class

Duty Cycle	24 hr. Continuous Operation
Wave Form Distortion	Nil True to Input
Response Time	Less Than 10ms
Correction Speed	Upto 70V per sec. (Dependent on Input Voltage & Capacity)
Correction Method	Step-leess Correction using Auto Variable Transformer
Suitability	Suitable for all Power Factor Loads
Break Down Strength & IR	300V AC for 2minutes, Greater than 50 Mega Ohms at 500V DC
No Load Loss	No Load Loss Less than 0.4%
Type & Suitability	Unbalanced Supply, Phase Unbalanced